jennings buckmaster 2000 compound bow manual

It wasn’t forgiving at all, and I couldn’t think why. You only need to worry if the Cam Lean is way too much.Īt the start of the outdoor season, I had an old set of carbon ones, with a new set on the way, so I didn’t tune my bow. But like I said, if you have a little Cam Lean, that’s OK. When Cam lean is off, the arrow angle will show you which side of the yoke you need to add or take twists from. I check if my Cam is straight or not by putting an arrow up against the Cam and checking the arrow relative to the string. I would suggest that you try to set up your Cam Lean to where it is perfectly straight. Which is not only bad for your bow but dangerous for you and anyone standing near you Groupingīow tuning plays a large part in your arrow grouping. It can cause the string to catch on the side of the cams, causing the bow to derail. If your Cam Lean is very bad, I would strongly recommend that you don’t shoot the bow. I would say, if it ain’t broke, don’t fix it…!Įxcessive Cam Lean can be dangerous. If it’s off and you adjust it – it will affect your tuning.

If you move your rest and you’re happy with the way your arrows are hitting the target, go ahead and check your Cam lean. As you can see, for your left and right, you can move your rest or add twists to your yoke. Here’s an info-graphic you might find helpful. Without moving my sight, I shoot my bare-shafts into my other three spot When I am happy with my fletched sight-mark (Your sight should not move!) I then shoot three fletched arrows into my three spot. I like to shoot and find a sight-mark for my fletched arrows at 18m or closer if you wish. I’ve got my fletched arrows and bare-shaft arrows. To bare-shaft tune, a compound bow, let’s talk about what you will need. That’s just a quick intro as to what it is now. On a right-handed bow, the yoke on the right will always need more twists than the left, simply because of the way the bow is built and the way the cams are put on.Ī left-handed bow, the yoke on the left will need more twists than on the right. Then vice versa, at the resting position, the string is under a lot of tension, but the cables are not. At full draw, the string doesn’t have much tension, but the cables (buss and yoke) do. The further back you pull, the more draw weight there is. When you pull back your bow, the energy in the limbs causes them to bend. But why does Cam Lean matter? Here’s why: Cam Lean, to put it simply, is – Cam angle relative to your drawstring.

Jennings buckmaster 2000 compound bow manual